Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
Table of Contents Transmitter and Receiver Binding ......4 Troubleshooting Guide ........10 Low Voltage Cutoff (LVC) ........4 Troubleshooting Guide (Continued) ......11 ESC/Receiver Arming, Battery Installation and Limited Warranty ..........11 Center of Gravity ...........5 Warranty and Service Contact Information ..13 Control Direction Tests ..........6 IC Information .............13 Control Centering ..........7 FCC Information ..........13...
Transmitter and Receiver Binding For a list of compatible DSM2/DSMX transmitters, please visit www.bindnfl y.com Binding Procedure ® CAUTION: When using a Futaba transmitter with a Spektrum DSM module, you must reverse the throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
ESC/Receiver Arming, Battery Installation and Center of Gravity CAUTION: Always keep hands away from the propeller. When armed, the motor will turn the propeller in response to any throttle movement. Arming the ESC/receiver also occurs after binding as previously described, but subsequent connection of a fl...
Control Direction Tests Traditional Control Direction Test You should bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. Make sure the tail linkages move freely and that paint or decals are not adhered to them.
Control Centering Before your fi rst fl ight make sure the aircraft’s control surfaces are centered. 1. Power on the transmitter and then the aircraft. 2. Set all transmitter trims and sub-trims to zero. 3. Check the control surfaces to make sure they are centered.
Flying Tips and Repairs We recommend fl ying your aircraft outside in calm Failure to lower the throttle conditions. Always avoid fl ying near houses, trees, stick and trim to the lowest CAUTION: wires and buildings. You should also be careful to possible positions during a Always decrease avoid fl...
Power Components Service Disassembly CAUTION: DO NOT handle the propeller while the fl ight battery is connected to the ESC. Personal injury could result. Propeller 1. Carefully remove the screw (A) and propeller (B) from the motor shaft. Motor 1. Remove the battery hatch by gripping the front of the hatch, then pulling it up and away from the fuselage.
Troubleshooting Guide AS3X Problem Possible Cause Solution Control surfaces not at Control surfaces may not have been Center control surfaces mechanically by neutral position when mechanically centered from factory adjusting the U-bends on control linkages transmitter controls are Aircraft was not kept immobile for 5 Keep the aircraft immobile for 5 seconds after at neutral seconds after battery was plugged in...
Limited Warranty What this Warranty Covers OTHER THAN THE EXPRESS WARRANTY ABOVE, Horizon Hobby, LLC, (Horizon) warrants to the HORIZON MAKES NO OTHER WARRANTY OR original purchaser that the product purchased (the REPRESENTATION, AND HEREBY DISCLAIMS ANY “Product”) will be free from defects in materials and AND ALL IMPLIED WARRANTIES, INCLUDING, workmanship at the date of purchase.
Page 12
Horizon reserves the right to inspect any and all without additional protection. Ship via a carrier Product(s) involved in a warranty claim. Service or that provides tracking and insurance for lost or replacement decisions are at the sole discretion damaged parcels, as Horizon is not responsible for of Horizon.
Compliance Information for the European Union Instructions for disposal of WEEE by users in the European Union EFL UMX Waco BNF Basic (EFLU5350) This product must not be disposed of with other waste. Instead, it is the EU Compliance Statement: Horizon Hobby, LLC user’s responsibility to dispose of their...
– Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Parti opzionali e accessori – Part # • Nummer Description Beschreibung Description Descrizione Numéro • Codice Hook and Loop Set Klettband (5): Ultra Bande auto- Set fascette fi...
Need help?
Do you have a question about the UMX WACO and is the answer not in the manual?
Questions and answers