Horizon Hobby UMX Aero Commander Instruction Manual
Horizon Hobby UMX Aero Commander Instruction Manual

Horizon Hobby UMX Aero Commander Instruction Manual

Advertisement

Quick Links

UMX
Aero Commander
Instruction Manual
Bedienungsanleitung
Manuel d'utilisation
Manuale di Istruzioni

Advertisement

Table of Contents
loading

Summary of Contents for Horizon Hobby UMX Aero Commander

  • Page 1 Aero Commander ™ ™ Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni...
  • Page 2: Safety Precautions And Warnings

    Do not use with incompatible components or alter this product in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
  • Page 3: Specifications

    Specifications 28.15 in (715mm) Installed Motor: (2) BL180 Brushless Outrunner 3,000Kv (EFLUM180BLB) Receiver : DSM2 6 Ch. UM AS3X ® ® BL-ESC (EFLAS6410NBLT) (2) 2.3-Gram Performance Linear Long Throw Offset Servo (SPMSA2030LO) Required to Complete Battery: 450-800mAh 2S 7.4V 30C Li-Po, ( EFLB4502SJ30, EFLB8002SJ30) Wing Area: 119.0 sq In...
  • Page 4: Transmitter And Receiver Binding

    Transmitter and Receiver Binding Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) ™ code of a single specific transmitter. You need to ‘bind’ your chosen Spektrum DSM2/DSMX technology equipped aircraft transmitter to the receiver for proper operation. Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver.
  • Page 5: Transmitter Setup

    Transmitter Setup To obtain the best flight performance, Computerized Transmitter Setup we recommend using a DSM2 /DSMX ® ® (DX6e, DX6 G2, DX7 G2, DX8 G2, DX9, DX18 and DX20) transmitter capable of Dual Rates. Before binding, ensure that you are starting with a Start all transmitter programming with a blank ACRO model blank acro model in your transmitter.
  • Page 6: Esc/Receiver Arming, Battery Installation And Center Of Gravity

    ESC/Receiver Arming, Battery Installation and Center of Gravity CAUTION: Always keep hands away from the propeller. When armed, the motor will turn the propeller in response to any throttle movement. Arming the ESC/receiver also occurs after binding as previously described, but subsequent connection of a flight battery requires the following steps.
  • Page 7: Control Direction Tests

    Control Direction Tests Traditional Control Direction Test You should bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. Make sure the tail linkages move freely and that paint or decals are not adhered to them.
  • Page 8: Control Centering

    Control Centering Before your first flight make sure the aircraft’s control surfaces are centered. 1. Power on the transmitter and then the aircraft. 2. Set all transmitter trims and sub-trims to zero. 3. Check the control surfaces to make sure they are centered.
  • Page 9: Flying Tips And Repairs

    Flying Tips and Repairs We recommend flying your aircraft outside in calm Failure to lower the throttle conditions. Always avoid flying near houses, trees, stick and trim to the lowest CAUTION: wires and buildings. You should also be careful to possible positions during a Always decrease avoid flying in areas where there are many people,...
  • Page 10: Power Components Service

    Power Components Service Disassembly CAUTION: DO NOT handle the propeller while the flight battery is connected to the ESC. Personal injury could result. Propeller 1. Carefully remove the spinner (A) screw (B) and propeller (C) from the motor shaft (D). Motor 1.
  • Page 11: Troubleshooting Guide

    Troubleshooting Guide AS3X Problem Possible Cause Solution Control surfaces not at Control surfaces may not have been Center control surfaces mechanically by neutral position when mechanically centered from factory adjusting the U-bends on control linkages transmitter controls are Aircraft was not kept immobile for 5 Keep the aircraft immobile for 5 seconds after at neutral seconds after battery was plugged in...
  • Page 12: Limited Warranty

    Limited Warranty What this Warranty Covers OTHER THAN THE EXPRESS WARRANTY ABOVE, Horizon Hobby, LLC, (Horizon) warrants to the HORIZON MAKES NO OTHER WARRANTY OR original purchaser that the product purchased (the REPRESENTATION, AND HEREBY DISCLAIMS ANY “Product”) will be free from defects in materials and AND ALL IMPLIED WARRANTIES, INCLUDING, workmanship at the date of purchase.
  • Page 13 Horizon reserves the right to inspect any and all without additional protection. Ship via a carrier Product(s) involved in a warranty claim. Service or that provides tracking and insurance for lost or replacement decisions are at the sole discretion damaged parcels, as Horizon is not responsible for of Horizon.
  • Page 14: Warranty And Service Contact Information

    Horizon Technischer Service service@horizonhobby.eu Hanskampring 9 D 22885 Barsbüttel, Germany Sales: Horizon Hobby GmbH +49 (0) 4121 2655 100 IC Information IC: 6157A-6TWIN Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
  • Page 15: Compliance Information For The European Union

    Compliance Information for the European Union EU Compliance Statement: Horizon Hobby, LLC hereby declares that this product is in compliance with the essential requirements and other relevant provisions of the RED and EMC Directives. A copy of the EU Declaration of Conformity is available online at: http://www.horizonhobby.com/content/ support-render-compliance.
  • Page 16 Replacement Parts – Ersatzteile – – Pièces de rechange – Recapiti per i ricambi – Part # • Nummer Description Beschreibung Description Descrizione Numéro • Codice EFLU5801 Wing Wing Wing Wing Fuselage with tail Fuselage with tail Fuselage with tail Fuselage with tail EFLU5802 installed...
  • Page 17: Optional Parts And Accessories

    – Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Parti opzionali e accessori – Part # • Nummer Description Beschreibung Description Descrizione Numéro • Codice LiPo Charge Protection LiPo Charge Protection LiPo Charge Protection LiPo Charge Protection DYN1400...
  • Page 19 © 2017 Horizon Hobby, LLC. E-flite, AS3X, UMX, DSM, DSM2, DSMX, ModelMatch, Bind-N-Fly, BNF, Celectra and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.

This manual is also suitable for:

Eflu5850As3x

Table of Contents