Checking The Handlebars; Installing The Handlebars - Yamaha YZF-R7 Owner's Service Manual

Ofrecido por www.electromanuales.com
a a
UP UP UP
1 1
HANDLEBARS
EB704101
REMOVING THE HANDLEBARS
1. Stand the motorcycle on a level surface.
WARNING
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
2. Remove:
• handlebar grip
NOTE:
Blow compressed air between the left
handlebar and the handlebar grip, and
gradually push the grip off the handle-
bar.
EB704401

CHECKING THE HANDLEBARS

1. Check:
• left handlebar
• right handlebar
Bends/cracks/damage → Replace.
WARNING
WARNING
Do not attempt to straighten bent han-
dlebars as
weaken them.
EB704704

INSTALLING THE HANDLEBARS

1. Install:
• brake master cylinder holder 1
CAUTION:
ACHTUNG:
• Install the brake master cylinder
holder with the "UP" mark facing up.
• First, tighten the upper bolt, then the
lower bolt.
NOTE:
• Align the mating surfaces of the brake
master cylinder holder with the punch
mark a in the right handlebar.
• There should be 2 mm of clearance
between the right handlebar switch
and the brake master cylinder holder.
7 - 69
CHAS
this may dangerously
13 Nm (1.3 m · kg, 9.4 ft · lb)