Handlebar Switches; Clutch Lever; Turn Signal Switch; Engine Stop Switch - Yamaha YZF-R7 Owner's Service Manual

Ofrecido por www.electromanuales.com
INSTRUMENT AND CONTROL FUNCTIONS
1 1
3 3
2 2
4 4
5 5
1. Pass switch "PASS"
2. Lights switch
3. Dimmer switch

4. Turn signal switch

5. Horn switch " "

Handlebar switches

Pass switch "PASS"
Press the switch to operate the passing
light.
Start switch " "
The starter motor cranks the engine
when pushing the start switch.
CAUTION:
See starting instructions prior to
starting the engine.
Lights switch
Turning the lights switch to "
turns on the auxiliary light, meter lights
and taillight. Turning the lights switch to
" ", turns the headlight on also.
Dimmer switch
Turn the switch to "
beam and to " " for the low beam.
Turn signal switch
EAU00118
To signal a right-hand turn, push the
switch to " ". To signal a left-hand
turn, push the switch to "
EAU00120
the switch is released it will return to the
center position. To cancel the signal,
push the switch in after it has returned
to the center position.
Horn switch "
Press the switch to sound the horn.
EAU00143
1 1
a a
EC000005
1. Lever position adjusting dial
2. Arrow mark
a. Lever distance

Clutch lever

The clutch lever is located on the left
handlebar. It is equipped with a clutch
lever adjusting dial and a clutch switch,
which is integrated into the ignition cir-
cuit cut-off system. (Refer to the engine
starting procedures for a description of
this system.) To disengage the clutch,
pull the clutch lever toward the handle-
bar. To engage the clutch, release the
lever. The lever should be pulled rapid-
ly and released slowly for smooth
clutch operation.
1 - 9
EAU00134
",
EAU00121
" for the high

1. Engine stop switch

2. Start switch "
Engine stop switch
EAU00127
The engine stop switch is a safety de-
vice for use in an emergency such as
when the motorcycle overturns or if
trouble occurs in the throttle system.
". Once
Turn the switch to "
gine. In case of emergency, turn the
switch to "
EAU00129
"
To adjust the distance between the
clutch lever and the handlebar grip,
turn the clutch adjusting dial while
2 2
pushing the lever forward. Make sure
the setting on the clutch lever adjusting
dial is aligned with the arrow mark.
EAU00153
1 1
2 2
"
EAU00138
" to start the en-
" to stop the engine.