Table of Contents
Advertisement
H. Control Module Operation
1. The control module has an ON/OFF/REMOTE selector
switch that must be set.
OFF Position: Appliance will ignore all power inputs and
will not respond to any commands from a wall switch or
optional remote. The unit should be in the OFF position
during installation, service, fuel conversion, and in the
event that the control goes into LOCK-OUT mode as a
result of an error code.
ON Position: Appliance will ignite and run continuously
in the HI fl ame setting, with no adjustment in fl ame
output. This mode of operation is primarily used for
initial installation and inspection.
REMOTE Position: Appliance will initiate commands
from a wired wall switch and/or one of the optional
wireless remote options.
2. A wall switch can be wired into the control module brown
and red wires. See Figure 10.1 and Figure 10.2.
3. The control module has safety feature that automatically
shuts down the fi replace after 9 hours of continuous
operation without receiving a command from the wall
switch or optional remote.
4. If you intend to use both a wired wall switch and an
optional remote control to operate your fi replace, the
wall switch will override any commands given by the
remote.
5. The module has the capability to recognize potential
malfunctions. If these occur, it will fail to ignite and/or
respond to a command to ignite via the wall switch and/
or optional remote. In this case, the module may have
gone into LOCK-OUT mode. In this state, it will emit a
RED/GREEN LED error code. To reset the error code,
switch the selector to OFF, and then back to REMOTE
or ON. If the ignition command again fails, the module
will emit an LED error code, prior to going back into
LOCK-OUT mode. Contact your dealer for service if
this occurs.
Note: If the module is in LOCK-OUT mode, resetting the
circuit breaker to the appliance will also reset the module.
Note: For units installed in Australia, the residence's 220/240
wall outlet to which this appliance's power cord is connected,
must be wired to an in-line on/off switch. This is required for
servicing and/or resetting the control module in the event of
a control module LOCK-OUT.
10
Heat & Glo • Supreme-N-I30AU, Supreme-P-I30AU • 2222-900 Rev. C • 2/11
GRAY MODULE
HI/LOW FLAME
ADJUSTMENT
WIRE LEAD FROM REGULATOR CONNECTS HERE
Figure 2.3 Control Module
SELECTOR
SWITCH
NG/LP SETTING
Advertisement
Table of Contents
