Reel Torque - Sony SLV-D990P R Service Manual

QQ
3 7 63 1515 0
(4) Envelope Check
1) Make recordings on T-120 (E-120) and T-160 (E-180) tape.
Make sure the playback output envelope meets the specification as shown in Fig. 6-15.
2) Play back a self recorded tape (recording made on the unit using with T-120 (E-120).
The video envelope should meet the specification as shown in Fig. 6-15.
In SP mode, (A) should equal (B).
If the head gap is wide, upper cylinder should be checked.
(5) Tape Wrinkle Check
1) Run the T-160 (E-180) tape in the playback, FPS, RPS and Pause modes and observe tape wrinkle at each guide.
2) If excessive tape wrinkle is observed, perform the following adjustments in Playback mode :
Tape wrinkle at the guide roller S, T section : Linearity adjustment.
TE
L 13942296513
Tape wrinkle at tape guide flange : ACE head assembly coarse adjustment.

6-2-3 Reel Torque

1) The rotation of the capstan motor causes the holder clutch ass'y to rotate through the belt pulley.
2) The spring wrap PLAY/REV of holder clutch ass'y drives the disk reel S, T through gear idler by rotation of gear center ass'y.
3) Brake is operated by slider cam at FF/REW mode.
4) Transportation of accurate driving force is done by gears. (Gear Center Ass'y)
Note: If the spec. does not meet the followings specifications, replace the holder clutch ass'y and then recheck.
MODE
PB
RPS
www
.
http://www.xiaoyu163.com
A
Fig. 6-15 Envelope Input and Output Level
< Table 6-2 >
TORQUE g/cm
42 ± 11
Cassette Torquemeter
145 ± 30
Cassette Torquemeter
x ao
y
i
http://www.xiaoyu163.com
8
B
Q Q
3 6 7 1 3
GAUGE
u163
.
6-11
2 9 9 4 2 8
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9