Sony SLV-D990P R Service Manual page 108

QQ
3 7 63 1515 0
6) Play back the Mono Scope alignment tape (SP mode).
7) Connect an oscilloscope CH-1 to the "Envelope" and CH-2 to the "H'D SW Pulse" for triggering.
8) Turn the guide roller heads with a flat head (
TE GUIDE ROLLER S
L 13942296513
(3) Check Transitional Operation from RPS to Play
Check transition from RPS mode to play mode : Using a pre-recorded SP tape, make sure the entry side of envelope comes to an appropriate
steady state within 3 seconds (as shown in Fig. 6-14).
If the envelope waveform does not reach specified peak-to peak amplitude within 3 seconds, adjust as follows :
1) Make sure there is no gap between the supply roller lower flange and the tape.
If there is a gap, adjust the supply guide roller again.
2) Change operation mode from the RPS to the play mode (again) and make sure the entry side of envelope rises within 3 second.
www
Fig. 6-14 Video Envelope Rising when Operation mode Changes from RPS to Play Mode
.
http://www.xiaoyu163.com
) driver to obtain a flat video RF envelope as shown in Fig. 6-13.
IDEAL ENVELOPE
S HEIGHT TOO HIGH
S HEIGHT TOO LOW
Fig. 6-13 Guide Roller S, T Height Adjustment
ENTRANCE SIDE ENVELOPE
x ao
y
i
http://www.xiaoyu163.com
8
T HEIGHT TOO HIGH
T HEIGHT TOO LOW
Q Q
3 6 7 1 3
u163
.
6-10
2 9 9 4 2 8
GUIDE ROLLER T
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9