Arming / Dis-Arming Individual Areas In A Multi-Area System; If The Selected Area/S Will Not Arm; Unsealed Zones; Force Arming - Inner Range CONCEPT IQ User Manual

Version 2.02 December-2002

3.4 ARMING / DIS-ARMING INDIVIDUAL AREAS IN A MULTI-AREA SYSTEM.

The LED keypad allows the User to Arm and Dis-arm individual Areas in a Multi-Area system.
The Lamps A1 A2 A3 A4 show when each area is armed.
The procedure for Arming an individual Area is the same for Multi-Area and Single-Area mode.
The Area selected must be in the User's Area list.
Arming the system.
Enter PIN;
Dis-arming the system.
Enter PIN;

3.5 IF THE SELECTED AREA/S WILL NOT ARM

Unsealed Zones.

An Area cannot normally be Armed unless all the Zones assigned to the Area are Sealed.
If you perform an Arming operation and the Terminal sounds a Long Beep and the ARM or HOME
Lamp does not come on, it is probably because one or more Zones in the Area/s are unsealed.
You should check that all Zones in the Area/s are Sealed, or you may need to Isolate Zones that
cannot be sealed, before attempting the Arming operation again.
NOTE: Force Arming.
Your system may have the "Force Arming" function enabled. (Consult the Installer if you are unsure)
Force Arming allows an Area to be Armed, by following the normal Arming procedure, when there is
one or more un-sealed Zones in the Area.
This may be necessary when a Zone needs to remain un-sealed (e.g. A window), or is faulty.
CAUTION:
If the "Auto-Isolate" function is not enabled in your system, the un-sealed Zone/s will go into alarm.
If "Auto-Isolate" is enabled in your system, the un-sealed Zone/s will automatically be isolated.

3.6 ALARM DISPLAY AFTER DISARMING

Your system may have the "Alarm Display after Disarming" option enabled.
(Consult the Installer if you are unsure)
If this option is enabled and you Disarm an Area after an alarm has occured in the Area, the Terminal
will automatically display the alarms by Fast Flashing on the Zone Lamps.
When you have noted the Zones that had an alarm, press
... , Area number
... , Area number
, then
, then
to exit to the normal display. .
9