Next; Telephone Remote Control - Inner Range CONCEPT IQ User Manual

26
Consult your installer to ascertain whether your system has the optional Telephone Remote Control enabled.
(Telephone Remote Control requires the DTMF Card to be fitted to the Control Module)
TELEPHONE KEY FUNCTIONS:
The following Telephone Keys are used to perform the specified LED Terminal functions:
IMPORTANT NOTE: Use short key presses. If keys are held down they may register as multiple presses.
<*>
<#>
<9>
OPERATION:
Call the system and Logon:
1) Dial the telephone number of the system from a Touch-tone (DTMF) telephone or Mobile phone.
2) When the Control Module answers you will hear a brief tone.
3) When the line is quiet, enter your PIN Code on the telephone keypad.
4.1) To Arm or Disarm the System:
To Arm:
To Disarm:
e.g. To Arm Area 2.
The Control Module will then reply with a Status message:
- A series of Beeps of the same tone to indicate Area On.
- A series of Beeps of 2 different tones to indicate Area Off.
- A series of Beeps of 8 different tones to indicate the operation could not be performed.
IMPORTANT NOTE: You MUST wait to here the Status message beeps before attempting another command.

5. Telephone Remote Control

Arm
Disarm / Toggle On/Off

NEXT

System Telephone Number:
-All Areas in your Area List.
-A specific Area. (Multi-Area system only) Press <Area Number>, <*>
-All Areas in your Area List.
-A specific Area.
Press: 2, <*>.
Version 2.02 December-2002
................................................
Press <*>
Press <#>
Press <Area Number>, <#>