Wlan Antennas - HP ProDesk 400 G1 Maintenance And Service Manual

WLAN antennas

The antennas route from the WLAN module to the cable connectors on the rear of the computer.
To install the antennas:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Remove the drive cage
5. Remove the heat sink
6. Remove the fan
7. Disconnect the WLAN antenna cables from the WLAN module.
8. Remove the system board
50 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page
(Drive cage on page
(Heat sink on page
(Fan on page 36).
(System board on page
18).
19).
37).
33).
46).
17).