System Board - HP ProDesk 400 G1 Maintenance And Service Manual

System board

NOTE: All system board spare part kits include replacement thermal material.
NOTE: System board appearance may vary.
Description
System board for use in models without Windows 8.1
System board for use in models with Windows 8.1 Standard
System board for use in models with Windows 8.1 Professional
System board for use in NetClone models
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Remove the drive cage
5. Remove the heat sink
6. Remove the fan
7. Remove the solid-state drive (if installed)
8. Remove the memory modules
9. Remove the WLAN module
10. Remove the processor
11. Disconnect all cables from the system board, noting their location for reinstallation.
12. Remove the two Torx screws (1) that secure the system board to the computer.
46 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page
(Drive cage on page
(Heat sink on page
(Fan on page 36).
(Memory on page
(WLAN module on page
(Processor on page
18).
19).
37).
33).
(M.2 solid-state drive on page
26).
39).
34).
17).
41).