Table of Contents
Advertisement
Zoom
Use the zoom menu to enable 1X and 2X digital zoom on the cameras. While zoomed in, you can
scan the image and view channels in full-screen.
NOTE: Zoom is intended as a temporary setting that is applied to ALL CHANNELS. When you are
finished using zoom, you should return the view to 1X view.
Figure 12.3 Zoom menu
To set the zoom:
1. View camera 1, 2, 3 or 4 in single-channel full-screen.
2. From the Main Menu, select Setting and press the Enter/OK button.
3. From the Settings menu, select Zoom and press the Enter/OK button.
4. Select X 1 or X 2 and press the Enter/OK button.
5. Press MENU until all menu windows are closed. The selected camera will be shown on the
main display in 2X zoom.
While zoomed in you can perform the following:
•
Press LEFT/RIGHT/UP/DOWN to scan the image.
•
Press CHANNEL—M to change channels manually (you can only change channels using
the CHANNEL—M button while zoomed in)
•
Press CHANNEL—A to enable Auto Sequence Viewing Mode
•
Press the Record—
wireless receiver to start/stop manual recording
•
Press QUAD to view Quad mode – all channels will be zoomed-in
To disable zoom:
1. Open the Zoom menu.
2. Select X 1 and press the Enter/OK button.
3. Press the MENU button until all menu windows are closed.
button on the remote control or RECORD—M button on the
Using the Main Menu
43
Advertisement
Table of Contents
