Bluetooth Function - Sony UP-DX100 Operating Instructions Manual

2
Remove the paper tray, and remove the jammed
paper from the paper tray slot.
3
Remove the cover on the rear panel, and check that
the paper does not remain in the printer. If the
jammed paper is still in the printer, remove it.
- A
C IN
Rear cover
4
After removing the jammed paper, be sure to
replace the rear cover.
5
Insert the paper tray.
6
Turn on the printer.
Note
If you cannot remove the jammed paper, contact your
Sony service facility or your Sony dealer.
Cleaning the inside of the printer
If white lines or dots are printed on the pictures, clean
inside the printer using the supplied cleaning cassette
and the protective sheet contained in the printing pack.
Notes
• Make cleaning only when there are white lines or dots
on the print.
• When you can obtain proper printing performances,
cleaning will not improve the printed picture quality.
1
Remove the paper tray from the printer. If there is
print paper in the tray, remove the print paper from
the tray.
2
Place the protective sheet with the imprint side
facing down and the arrow pointing in the same
direction as the arrow in the tray.
3
Open the cartridge compartment cover and remove
the print cartridge.
22
Troubleshooting
g
- A
C IN
Jammed paper
White lines
4
Insert the supplied cleaning cassette into the printer
and close the cartridge compartment cover.
A buzzer sounds, and "HEAD CLEANING/PUSH
[EXEC]" appears on the operation display.
5
Press the EXEC button.
The cleaning cassette and protective sheet will
clean inside the printer. After the cleaning is
finished, the protective sheet is automatically
ejected.
6
Remove the cleaning cassette from the printer and
set the print cartridge and print paper.

Bluetooth Function

Symptom Cause/Action
Data cannot be • The distance between the device and the
transmitted. printer is too great.
tLocate the devices within the
maximum communicable distance.
• The Bluetooth antenna portion of the
printer and/or the camera is covered with
a hand, etc.
tDo not cover the antenna portion.
• The device you wish to connect with the
printer has been already connected with
another device.
tReconnect the device with the printer
after the device's task with another
device is finished.
• Authentication failed.
tReconnect the printer with the device,
and enter the same passkey correctly
on both devices.
• The connected device interrupted the
transmission.
tCheck the status of the connected
device, then reconnect.
• The Bluetooth connection is interrupted
on the side of the connected device.
tCheck the status of the connected
device.
The connection is • The authentication time limit (30
disconnected from seconds) elapsed.
the desired device.
tEnter the same passkey correctly both
on the printer and the device within
30 seconds.
• The same passkey is not entered.
tEnter the same passkey correctly both
on the printer and the device within
30 seconds.
• The device disconnected or ended the
connection.
tCheck the status of the device, try to
connect to the device again, and enter
the passkey correctly.