Leveling/Adjustments/Alignment; Anti-Tip Device Installation - Viking VESC530-4B Installation Manual

Leveling/Adjustments/Alignment

1
Measure the four corners in cutout area to
verify if flooring is level.
3
Move unit into opening.
5
If leveling is required, move unit out of opening.
18
2
For uneven or sloped floors, level unit with
metal shims only, as the adjustment required may
exceed the thread available in the leg.
4
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to
side and front to back. Side trim of the high corner
must be 3/8" (0.95 cm) above countertop.
6
1
1
Lift unit and prop on wood blocks.
7
Set the high corner of range so that the top of side trim is
3/8" (0.95 cm) above countertop. Level range to high corner.

Anti-tip Device Installation

WARNING
Tipping hazard.
To reduce the risk of the appliance
tipping, it must be secured by a
properly installed anti-tip
bracket(s). To make sure the
bracket has been installed
properly, look behind the range
with a flashlight to verify proper
installation engaged in the rear
top left corner of the range.
• THIS RANGE CAN TIP.
• INJURIES TO PERSONS CAN RESULT.
• INSTALL ANTI-TIP DEVICE PACKED
WITH RANGE.
• SEE INSTALLATION INSTRUCTIONS.
2
3 - 5 3 - 5 3 - 5
/ 8 / 8 / 8
( 9 . ( 9 . ( 9 .
" " "
2 c 2 c 2 c
m ) m ) m )
m ) m ) m )
) ) )
( A ( A ( A
3 c 3 c 3 c
( 1 . ( 1 . ( 1 .
/ 2 " / 2 " / 2 "
+ 1 + 1 + 1
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/2" (1.3 cm) from the floor and 3-5/8" (9.2 cm)
from where the right side of range (facing range) is to be located.
19
1
( A ( A
) )
Measure from floor to bottom
of the anit-tip opening located on the back of range.
This will be measurement (A).
3
Mark and drill holes where bracket
will be located.