Table of Contents
Advertisement
Electrical Connection (4-wire)
(cont.)
Bare Wire Connection
Eyelet Connection
1
1
To make a bare wire connection, use holes on the left
side of the terminal block. To connect eyelet style
wires, use holes on right side of terminal.
5
1
Attach ground lead (green)
with ground screw that was removed.
leads to outside terminal. Attach neutral wire (white) to
7
1
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain
relief bracket over supply cord.
18
4
Feed supply cord up through hole in bottom
of range back.
6
1
Attach line #1 (red) and line #2 (black)
center terminal on terminal block.
8
Reattach access door.
Leveling/Adjustments/Alignment
1
Measure the four corners in cutout area
For uneven or sloped floors, level unit with metal shims
to verify if flooring is level.
3
Move unit into opening.
side and front to back. Side trim of the high corner
5
If leveling is required, move unit out of opening.
19
2
only, as the adjustment required may exceed
the thread available in the leg.
4
"
"
"
3 / 8
3 / 8
3 / 8
)
)
)
c m
c m
c m
9 5
9 5
9 5
( 0 .
( 0 .
( 0 .
Check that unit is level side to
must be 3/8" (0.95 cm) above countertop.
6
1
1
Lift unit and prop on wood blocks.
Advertisement
Table of Contents
