Mitsubishi MJ-EZ6CX-S1-IT Service Manual page 37

( 5 ) Removing and replacing the power control board
① Pull out the water tank.
→ ( Reference : Removing the water tank )
② Remove the left case.
→ ( Reference : Removing the left case )
③ Remove the operation control board.
→ ( Reference : Removing and replacing the operation control
board )
④ Remove the power control board holder setscrew ( 1 ) from the
inside of the louvre of the right case.
⑤ Detach the fitting ( 5 ) of the power control board holder to
remove the power control board holder ( top ) .
⑥ Remove the power control board setscrew ( 1 ) .
⑦ Remove all the connectors of the power control board to
remove the power control board.
→ ( Removing and replacing the power control board )
( 6 ) Removing and replacing the plug cord
① Remove the power control board holder ( top ) , and then
remove the connector P1 from the power control board.
→ ( Reference : Removing and replacing the power
control board )
② Detach the fitting which fixes the plug cord holder from
the lower part of the right case as the arrows indicate
in the picture to remove the plug cord holder.
③ Detach the fitting ( 4 ) of the plug cord holder to remove
the plug cord.
→ ( Removing and replacing the plug cord )
< Point at reassembly >
The plug cord should be attached to the plug cord
holder as shown in the Pic. .
Fitting ( 2 )
③
Plug cord holder
Power control board holder ( top )
⑤
Fitting ( 3 )
Fitting ( 2 )
③
Plug cord holder
Power control board holder setscrew
④
Fitting ( 2 )
⑤
Power control board holder
⑥
⑦
Power control board setscrew
①
Power control
board ( P1 )
Plug cord holder
②
Fitting
Plug cord holder
③
Louvre
Power control board
Plug cord holder
Fitting
Plug cord
37