Installation Of The Hood - Pkm 9080 Instruction Manual

6. When an exhaust duct is used, the ending of the exhaust hose must be adjusted
in the direction of flow.
7. If the exhaust duct passes through cool areas (e.g. an attic), a temperature
gradient may occur in the different parts of the exhaust duct so condensate will
be generated. Proper insulation of the corresponding parts of the exhaust duct
will then be needed. Equip such an exhaust duct with a condensate trap if need
be.
A Telescopic chimney
B Base chimney
Strictly observe the minimum distance between hood and hob.
Clean the surrounding of the installation area before you install the appliance so
the appliance will not extract any dust or construction waste.
The exhaust hose must not run in the same exhaust duct as gas tubes, hot air
tubes et cetera.
Lead away the exhaust hose from the hood as straight as possible.
The proper maximum bending angle outwards is 120
Check with a bubble level that the appliance is horizontally positioned while
installing and after having installed it.
C
D

Installation of the hood

31
Hood
Hob
0
.