The Handy THDS Operator's Manual And Parts List page 3

3. ASSEMBLY INSTRUCTIONS
STEP 1
1. As per Pic. 1, insert a Flat Washer Ø12, a Bushing and a Poly Wheel onto one end of the Wheel
Axle. Then place a Flat Washer Ø12 onto the Wheel Axle and insert a Cotter Pin Ø3X30 into the Ø3
hole on the Wheel Axle and bend to lock it.
2. Insert a Flat Washer Ø12, a Bushing, a Poly Wheel at the other end of the wheel axle. Then place
a Flat Washer Ø12 onto the Wheel Axle. Turn the wheel until the Ø5 hole on the wheel is in-line with
the Ø5 hole on the wheel axle, insert the Cotter Pin Ø5X45 and bend to lock it.
STEP 2
1. As per Pic. 3, insert two Hex Bolts M6X35 with Big Flat Washers Ø6 through the inner hopper and
a leg, then lock using two Wing Nuts M6. Tighten the nuts.
2. Repeat to assemble the other leg. See Pic.4.
3