Related Manuals for Xtreme Power Conversion 700VA
Summary of Contents for Xtreme Power Conversion 700VA
- Page 1 T90 Online UPS 700VA, 1000VA, 1500VA, 2000VA, 3000VA Models User & Installation Manual www.xpcc.com | © 2014 Xtreme Power Conversion Corporation. All rights reserved. (Rev 9/15/14)
-
Page 2: Table Of Contents
Connecting the UPS to a Computer....................22 RS-232 Standard Interface Port.....................22 USB Port (option)...........................23 EPO Port (Emergency Power Off)....................23 Network Transient Protector......................23 Load Segments..........................23 User’s Guide To Operations.................24 Starting And Shutting Down The UPS....................24 Xtreme Power Conversion Corporation Page 2... - Page 3 T90 User’s Manual Uninterruptible Power Supply Button Operation...........................24 Control Panel Functions.........................25 Troubleshooting..........................28 Maintenance....................29 Replacing Batteries........................29 Technical Specifications................31 Terminal Block....................32 Obtaining Service..................33 Xtreme Power Conversion Limited Warranty..........34 Xtreme Power Conversion Load Protection Policy........35 Xtreme Power Conversion Corporation Page 3...
- Page 4 UPS, please refer to the Troubleshooting section in this manual to correct the problem. If the problem is not corrected, please collect information so that the Technical Support personnel can more effectively assist you. Xtreme Power Conversion Corporation Page 4...
-
Page 5: Emc Statements - Fcc Part 15
• CAUTION: Risk of electric shock. Heat sinks are live. Disconnect unit before servicing. • CAUTION (UPS Having Internal Batteries): Risk of electric shock - Hazardous live parts inside this unit are energized from the battery supply even when the input AC power is disconnected. Xtreme Power Conversion Corporation Page 5... - Page 6 • CAUTION (FOR 1500VA HV Only): To reduce the risk of fire. Connect only to a circuit provided with 20 amperes maximum branch circuit overcurrent protection in accordance with the National Electric Code, ANSI/NFPA 70”. Xtreme Power Conversion Corporation Page 6...
-
Page 7: Special Symbols
RJ45 RECEPTACLE – The receptacle provides network interface connections and telephone or telecommu- nications equipment should not be plugged into it. Please do not discard of the UPS or the UPS batteries as the UPS may have valve-regulated lead-acid bat- teries. Please recycle batteries appropriately. Xtreme Power Conversion Corporation Page 7... -
Page 8: Introduction
• DC power is converted to AC in the inverter passing it on to the load. • Power is maintained from the battery during a power failure. • The converter increases voltage appropriately for the inverter Xtreme Power Conversion Corporation Page 8... -
Page 9: Efficiency Optimizer Function
• Backup time needed will indicate the battery size needed. If load is less than the UPS nominal power rating then actual backup time is longer. • The following options are available: • External Battery Cabinets • Transformer cabinets • Maintenance bypass switches • Connectivity options (relay card, SNMP/WEB card) Xtreme Power Conversion Corporation Page 9... -
Page 10: System Configuration
All such operations are to be performed exactly as instructed in this manual. The greatest care possible must be taken for any of these operations and any change thereof may prove very hazardous to the operator. Xtreme Power Conversion Corporation Page 10... -
Page 11: Storage
The External Battery Cabinets has to be installed next to the UPS or under the UPS. Installations with accessories of “Vertical” and “Wall-mounted” types: Please install the vertical and wall-mounted types of units according to the following illustration. 5 in 1 RACK-MOUNT BRACKETS : 94A-VM1K-000*4 , 641-5008-410*16 Xtreme Power Conversion Corporation Page 11... - Page 12 Mount the 2U rack-mount in a 19-inch EIA 310 C standard rack. 19” rack 2. 23” Rack installation: Change the position of the two mounting brackets to mount the 2U rack-mount in a 23-inch EIA 310 C standard rack. 23” rack Xtreme Power Conversion Corporation Page 12...
- Page 13 4. Wall installation: Move the mounting brackets from the front to the side and attach the brackets by screws. Then mount the UPS to the wall as the below pictures shown. Xtreme Power Conversion Corporation Page 13...
- Page 14 T90 User’s Manual Uninterruptible Power Supply 5. Installation with rear Bracket: We can use bracket to support the rear side of UPS or battery cabinet. Xtreme Power Conversion Corporation Page 14...
-
Page 15: Rear Panel Views
T90 User’s Manual Uninterruptible Power Supply Rear Panel Views 700-1.5kVA Rear Panel Xtreme Power Conversion Corporation Page 15... -
Page 16: Rear Panel Views
T90 User’s Manual Uninterruptible Power Supply Rear Panel Views 2kVA-3kVA Rear Panel Xtreme Power Conversion Corporation Page 16... - Page 17 T90 User’s Manual Uninterruptible Power Supply RM(1U) 700-1KVA Rear Panel Xtreme Power Conversion Corporation Page 17...
- Page 18 T90 User’s Manual Uninterruptible Power Supply RM(2U) 700/1K/1.5KVA Rear Panel Xtreme Power Conversion Corporation Page 18...
- Page 19 T90 User’s Manual Uninterruptible Power Supply RM(2U) 700/1K/1.5KVA Rear Panel Xtreme Power Conversion Corporation Page 19...
-
Page 20: Connection To Mains And Loads
• Should computer or alarm connections be used, use connections according to chapter 6 of the manual provided with that option. The connections can be referred to on the rear panel. The installation is now complete. Example of Installation of Plug & Play products Xtreme Power Conversion Corporation Page 20... -
Page 21: Default Settings At The Factory
External Battery pack setting 0, 1, 2 You may change default settings, but we recommend that this is done after installation and before starting up loads. Read UPS configurations in chapter 7.2 for more information. Xtreme Power Conversion Corporation Page 21... -
Page 22: Computer And Alarm Connections
Signal name Direction (re UPS) Functions Output TxD Output Input RxD / Inverter Off Input Common Common Output Ac Fail Output Output Low Battery Output Output 12 VDC Power Caution! Max rated values 12Vdc Xtreme Power Conversion Corporation Page 22... -
Page 23: Usb Port (Option)
The load group status can be viewed from the LCD display and can be changed if necessary. These load segments are usually handled with the UPS management software. Refer to chapter 5.2 regarding the two load segments that come with each model. Xtreme Power Conversion Corporation Page 23... -
Page 24: User's Guide To Operations
Push the “ ” button to enable your function. Push the “ ” button to confirm and enable your function. g. If no pressing within 10 seconds, it will return to original status. Xtreme Power Conversion Corporation Page 24... -
Page 25: Control Panel Functions
BAT CHARG= xx% Shows approximate percentage of Battery capacity TEMPERATURE= xxC Shows approximate ambient temperature BAT PACK NUM= x Shows External Battery Pack Number RATING = xxxxVA Shows UPS Rating CPU VERSION xx.x Shows CPU Version Xtreme Power Conversion Corporation Page 25... - Page 26 This setting is needed For UPS to external battery 1(one external cabinet) predict backup time Packs 2 (two external cabinets) You can enable or disable the site Site wiring alarm Sit Fault Set Enable /Disable Disable wiring alarm Xtreme Power Conversion Corporation Page 26...
- Page 27 By pressing any of the three buttons on the front panel, the alarm can be turned off, except when the battery is low, which will cause the alarm to resound. On the LCD display, you can also choose silent alarm mode which will not warn you of any malfunction audibly. Xtreme Power Conversion Corporation Page 27...
-
Page 28: Troubleshooting
Site wiring Fault second tral and Ground supply without ground. See page 15 on how to disable the Site wiring alarm 1 Beep per Wrong AC Line backed up Line abnormal second during auto restart Xtreme Power Conversion Corporation Page 28... -
Page 29: Maintenance
Attempting to make such alterations can cause injury. Replace the batteries with the same number and type as originally installed batteries. DO NOT DISCONNECT the batteries while UPS is in Battery mode. Replacing batteries (700 - 3000 VA) Xtreme Power Conversion Corporation Page 29... - Page 30 2. Remove the battery cartridge from the UPS. The voltage in all models will be less than 48Vdc once the bat- tery is disconnected from the UPS. 3. Replace the batteries. 4. Push the cartridge with the new batteries back into the UPS. 5. Reinstall the metal plate and the front panel. Xtreme Power Conversion Corporation Page 30...
-
Page 31: Technical Specifications
INCLUDED IN BOX User manual, monitoring software, CD, USB cable AVAILABLE OPTIONS Extended warranty, bypass distribution (XBDM), power distribution (XPDU) *T90-15HW 1500VA model available with input and output terminal blocks **Depending on load level Xtreme Power Conversion Corporation Page 31... -
Page 32: Terminal Block
(For 2000VA) Please refer to the terminal block connection diagram to connect and use No. 14 AWG, 90°C copper wire and 8 lb-in torque force when connecting. (For 1500VA) Xtreme Power Conversion Corporation Page 32... -
Page 33: Obtaining Service
RMA number marked on the outside of the boxes. 4. Return the UPS by insured, prepaid carrier to the address provided by the Technician. 5. Refer to the Warranty statements in this manual for additional details on what is covered. Xtreme Power Conversion Corporation Page 33... -
Page 34: Xtreme Power Conversion Limited Warranty
Purchaser’s sole and exclusive remedy for breach of any warranty, expressed or implied, concerning Xtreme Power Conversion equipment, and the only obligation of XPC Corporation under this warranty, shall be the repair or replacement of defective equipment, components, or parts;... -
Page 35: Xtreme Power Conversion Load Protection Policy
T90 User’s Manual Uninterruptible Power Supply Xtreme Power Conversion Load Protection Policy THIS POLICY IS NOT A WARRANTY. REFER TO THE XPC CORPORATION, INC. LIMITED WARRANTY FOR INFORMATION CONCERNING THE WARRANTY FOR YOUR XPC PRODUCT. THE LIMITATIONS AND CONDITIONS CONTAINED IN THIS POLICY DO NOT AFFECT THE TERMS OF THE XPC LIMITED WARRANTY. - Page 36 Purchaser and the name of the power utility supplier for the location of the Connected Equipment. XPC will forward to the Purchaser a Load Protection Policy claims form, which Xtreme Power Conversion Corporation Page 36...
- Page 37 No employee of XPC or any other party is authorized to make any representations beyond those made in this agreement con- cerning the Load Protection Policy. XPC Corporation 230 Yuma Street Denver, CO 80223 1.800.582.4524 Xtreme Power Conversion Corporation Page 37...