Door Handle Assembly; Blower Speed Adjustment - Quadra-Fire 4300 Owner's Manual

4300 Wood Stove Series (ACC)
C. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, it must move
smoothly.
7. Install spring handle turning in a counter-clockwise
motion to desired location on door handle rod.
CAUTION
• Do NOT overtighten lock nut.
• Door handle needs to move smoothly.
Figure 24.1
Page 24
D. Adjusting The Blower Speed Control
The blower speed control for this unit is adjusted at the factory,
and normally does not require further adjustment.
NOTE: When the speed control is turned clockwise, it will
click on to high speed. Continue to turn the speed control
clockwise to decrease the speed. At full clockwise, the
blower should blow gently, but should not stop.
1. With the appliance plugged in, turn the speed control
knob to slow (full clockwise).
2. With a small screwdriver, adjust the blower speed by
turning the adjustment mechanism through the hole on
the side of the speed control.
3. Adjust the speed so the blower runs slowly, but does
not stop. Turn clockwise to slow the blower and
counterclockwise to increase the speed.
7037-135L
August 3, 2015