Snap Disc; Door Handle Assembly - Quadra-Fire MILLENNIUM 2100 Series Owner's Manual

C. Snap Disc
Service Part: SRV230-0470
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the

snap disc.

3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 23.1
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc
Magnet
Figure 23.1
March 26, 2020
D. Door Handle Assembly
NOTE: DO NOT over tighten locking nut; door handle
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown in Figure 23.2.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut but do not over tighten, the handle needs
to move smoothly.
7. Install spring handle turning in a counter-clockwise
motion to required 2 inch (51mm) clearance location on
door handle rod (Figure 23.2).
Locknut
Figure 23.2
Spade
Connectors
7039-802B
needs to move smoothly!
Service Part: SRV7039-008
Door Cross
Latch Cam
Section
Spacing
Washers
Spring
Handle
Door Handle
Shaft
Square Key
23