There are 16 customized protocols provided in the system, you can edit the protocol name; and choose whether to
enable the sub-stream.
2.
Choose the protocol type of transmission and choose the transfer protocols.
The protocol type and the transfer protocols must be supported by the connected network camera.
Note:
After adding the customized protocols, you can see the protocol name is listed in the dropdown list, please refer to
Figure 2. 22.
3.
Choose the protocols you just added to validate the connection of the network camera.
2.3.3 Editing IP cameras connected to the PoE interfaces
The PoE interfaces enables the NVR system to pass electrical power safely, along with data, on Ethernet cabling to
the connected network cameras.
Example:
As for NET-KOBI-IP-4CH, when you want to connect 1 online camera and connect 3 network cameras via PoE
interfaces, you must disable 1 PoE interface in the Edit IP camera panel.
To add Cameras for NVR supporting PoE function:
Before you start:
Connect the network cameras via the PoE interfaces.
Figure 2. 21 Protocol Management Interface
Figure 2. 22 Protocol Setting
31