Setting Hdd Property - kobi NET--IP-4CH User Manual

7. Select the Group number for the current HDD.
The default group No. for each HDD is 1.
Note:
8. Click the OK button to confirm the settings.
9. In the pop-up Attention box, click the Yes button to finish the settings.

10.3.2 Setting HDD Property

Purpose:
The HDD property can be set to redundancy, read-only or read/write (R/W). Before setting the HDD property,
please set the storage mode to Group (refer to step1-4 of Chapter Setting HDD Groups ).
A HDD can be set to read-only to prevent important recorded files from being overwritten when the HDD becomes
full in overwrite recording mode.
When the HDD property is set to redundancy, the video can be recorded both onto the redundancy HDD and the
R/W HDD simultaneously so as to ensure high security and reliability of video data.
Steps:
1. Enter the HDD Information interface.
Menu > HDD> General
2. Select HDD from the list and click the
Figure 10. 14.
Figure 10. 12 Local HDD Settings Interface
Figure 10. 13 Confirm HDD Group Settings
icon to enter the Local HDD Settings interface, as shown in
139