Troubleshooting Guide - Daewoo DWD-GM1011 User Manual

TROUBLESHOOTING GUIDE

Problem
The machine
fills overtime.
There is a Door
lock alarm.
The machine
drains overtime.
Water overflows
the machine.
/ Water sensor
works abnormal.
The motor does
not work.
There is a
heating tube
fault.
There is a
temperature
sensor fault.
NOTE :
Technical repairs should only be undertaken by a suitably qualified person.
DWD-GM1011_영국향.indd 19
Error Code
"Spin" LED flickers. 1. The water tap is not open.
2. The drain hose is put down.
3. The water inlet valve is
damaged.
"Rinse" LED flickers. 1. The door is not locked well.
2. garment is caught between
the door and the seal.
3. The door lock is damaged.
"Rinse" and "Spin" 1. The drain hose is squashed
LEDs flicker. or kinked.
2. The drain pump filter is
block.
3. The drainage system pipes
are blocked.
"Washing" LED 1. The water inlet valve is
flickers. damaged.
2. The connection between the
water sensor and wire is not
secure.
3. The water sensor is
damaged.
"Washing" and "Spin" 1. The connection between the
LEDs flicker. motor and wire is not secure.
2. The motor is protected
because of over-heat.
3. The motor is damaged.
"Washing" and 1. The connection between the
"Rinse" LEDs flicker. heating tube and wire is not
secure.
2. The heating tube is
damaged.
"Washing", "Rinse" 1. The connection between the
and "Spin" LEDs temperature sensor and wire
flicker. is not secure.
2. The temperature sensor is
damaged.
Possible Cause
1. Open the water tap.
2. hook up the hose.
3. Change the water inlet
valve.
1. Lock the door well.
2. Put the garment into the
drum.
3. Change the door lock.
1. Check the drain hose.
2. Clean the filter.
3. Check the drainage system
and clean it.
1. Change the water inlet.
2. Check the connection and
ensure it is secure.
3. Change the water sensor.
1. Check the connection and
ensure it is secure.
2. Check if the machine is
overloaded. Switch off the
machine, and retry when the
motor becomes cool.
3. Change the motor.
1. Check the connection and
ensure it is secure.
2. Change the heating tube.
1. Check the connection and
ensure it is secure.
2. Change the temperature
sensor.
18
Solutions
2013-09-23 오전 11:42:02