Sony SCD-C222ES Service Manual page 18

SCD-C222ES
Set Check
92. SET CHECK
[ AMS ]
dial when No.sssss sssss*1 is displayed, and a checking for that display will start or the lower layer
Press the l L
will be selected. For the selection on the same layer, rotate the
[ AMS
displayed, press the l
*1 s denotes a displayed character.
Manual Check Method
In the "12. MANUAL CHK", individual checks (121. LOAD IN to 12A. LOAD OUT) are possible.
Example: If 124. READ TOC & PSP of 12. MANUAL CHECK is to be checked.
Setting Method:
1. After setting the test mode, rotate the
2. When "SET TEST START" is displayed, rotate the
[ AMS
and press the
l
3. When "10. TOTAL CHECK" is displayed, rotate the
[ AMS
press the
l L
4. When "120. MANUAL CHK" is displayed, rotate the
[ AMS
and press the l
5. A checking will start automatically.
Note: In making a check, the disc must be loaded. Immediately when a check started, the tray is drawn into the set. Also, the tray can be opened/closed
even during the set check mode.
18
SET TEST START
0. IC&FL CHECK ?
1. TOTAL CHECK ?
2. F.JUMP CHECK ?
3.HYB CHECK ?
4. DISP ERROR ?
END ??
]
L dial to return to the upper layer.
[ AMS ]
l L
[
l
]
dial to enter.
L
[
l
]
dial to enter.
[
l
]
L dial to enter.
10. TOTAL CHECK
11. AUTO CHECK ?
12. MANUAL CHK ?
13. DISP RSLT ?
TOTAL CHK END ?
[ AMS ]
l L dial. It is looped on the same layer, and when "END?" is
dial to select "92. SET CHECK" and press the
AMS ]
L dial clockwise by 2 clicks to select "1. TOTAL CHECK?"
AMS ]
L dial clockwise by 2 clicks to select "12. MANUAL CHK?" and
AMS ]
dial clockwise by 4 clicks to select "124. READ TOC & PSP?"
L
120. MANUAL CHK
121. LOAD IN ?
(Not used)
122. SPIN UP ?
123. PARAMETER ?
124. READ TOC & PSP ?
125. 1/3 SEEK ?
126. 1-M SEEK ?
127. ERR RATE ?
128. HENSHIN ?
129. SPIN DOWN ?
12A. LOAD OUT ?
(Not used)
MAN. CHK END?
[ AMS ]
l L dial to enter.