Clarion DC425 Owner's Manual page 13

Recalling ISR
Press the ISR button [j]J then the display will
show "ISR", then the radio station previously
memorized will be selected. Press the ISR but-
ton
[j]J
again to disengage the unit from the
Recalling ISR function.
CD Mode Operations
Loading a Disc
Insert the disc into the CD insertion slot with its
label side up, then the CD will start playing.
For 5-ineh (12 em) CD For 3-ineh (8 em) single CD
*
Press the DISP button [1], then the display will show
the play time.
Notes:
• Some CDs recorded in CD-R/CD-RW mode may not
be usable.
..
..
... ..
i·~ .. .f ::::~
· . · . · . ·
.
· . · .
.
.
. .
.
.
. .
;
~
..
_;
*
When inserting a single CD (3 "(8 cm)), insert it from
the center of the slot.
*
When inserting a single CD (3 "(8 cm)), do not con-
nect an adapter.
Listening to the Disc already Inserted
Press the FUNC button
rn
to select the CD
mode, the CD will start playing.
Stopping (pausing) Playback
Press the Play/Pause button
[1]].
Press the Play/Pause button
[1]]
again to resume
playback.
Ejecting the CD
Press the Eject button
[ID,
then the CD will be
ejected.
Note:
• If the ejected CD is left as it is, it will be reloaded after
15 seconds. However, single CDs will not be
reloaded, so make sure to remove them.
~--
~
Initial Setting New Setting
- -
(U.S. standard) (outside U.S.)
----.
Frequency
10 kHz 9 kHz
spacing
AM - - - - - - -
--
Frequency
530 to 531 to
range
1,710kHz 1,629 kHz
- - -
- - ~ - - ~
Frequency
200 kHz 50 kHz
spacing
FM - - - - - -
- - - - - - - - -
- - - - - - - -
Frequency
87.9 to 87.5 to
range
107.9 MHz 108 MHz
Area Change
Use this function when you are using the car
stereo anywhere outside the U.S.
Switchable frequency spacing
This car stereo is initially set to tune in frequen-
cy intervals of 10kHz for AM and 200 kHz for
FM, the standard calibrations in the U.S. When
using the unit outside the U.S., use the following
procedure to switch the frequency range.
The table below lists the frequency specifica-
tions for the U.S. and other countries.
Switching the area change
Outside U.S. (New Setting)
While pressing the BAND button
@],
press the
SRCH Left button
rn,
then "outside U.S." will be
selected.
Inside U.S. standard (Initial Setting)
While pressing the BAND button
@],
press the
tl
SR€H Right button
rn,
then the "U.S. standard"
will be selected.
DX425
13