Electrolux EDW 1506 Service Manual page 32

6.12. Customer function / deactivation of rinse-aid addition
General information
The function rinse-aid deactivation does not exist generally
and must be programmed in the software variant.
w Deactivation resp. activation of rinse-aid addition is executed
in all designs resp. key arrangements analogously.
w For that you always have to use keys S0, S1, S2 and S3
independent of their variant-depending program load.
w Key S2 is ALWAYS the "rinse-aid deactivation key"
w The rinse-aid addition is always set active by the manufacturer.
w If the rinse-aid addition is deactivated it means that no more
rinse-aid is added via the detergent dispenser.
Along with the deactivation, a variant-depending existing
"rinse-aid" LED is deactivated generally.
EDW 1503 / VGA
LD1 LD2 LD3
1 99
S2 S3
Calling / changing / saving the rinse-aid addition deactivation
1. LD1 LD2 LD3 LD4 LD5
S1 S2 S3 S4 S5
LD1 LD2 LD3 LD4 LD5
2.
blinken
LD1 LD2 LD3
3.
S2 S3
blinkt
LD2
4.
1d
S2
blinkt
LD2
5.
0d
S2
blinkt
LD2
6.
S0
1d
S2
LD1 LD2 LD3 LD4 LD5 LD6
... AUS nach 60sek. automatisch
... AUS durch manuelle Betätigung über Ein/Aus
32
Calling the function "deactivate rinse-aid addition"
LD6
LD10
LD11
1. Appliance in switched-off condition
LD12
S6 S0
2. Switch on appliance with ON/OFF key S0 -- "prestart" mode
LD6
Ä All LEDs of the program and option keys are lit.
S0
3. Press keys S2 and S3 simultaneously until the
confirmation LEDs LD1, LD2 and LD3 are flashing.
4. By actuating the function key S2 you now can call the
function rinse-aid addition. The confirmation LED LD2
continues flashing, LEDs LD1 and LD3 go out.
The current condition whether the rinse-aid addition is
active or not is indicated in the display.
1d = rinse-aid addition on / 0d = rinse-aid addition off
Deactivation resp. activation of rinse-aid addition:
5. / 6. By any further actuation of the function key S2 you activate
resp. deactivate the addition alternating.
Leaving the function
After the last key pressure of the function key S1 you can
leave the special program as follows.
After 60 seconds all LEDs of the program and option keys
S0
are lit automatically. The indication in the display goes out.
The appliance is in the "prestart" mode again
or
the appliance is switched off by ON/OFF key S0.
S0
Saving the set condition
The currently valid condition is saved directly after
any entry.
When calling the service functions no washing cycle
must be selected generally!