Electrolux EDW 1506 Service Manual page 28

6.8. Input philosophy: interrupt program
l
Interrupt program
w
Using the ON/OFF key S0 it is possible to interrupt the program as long as one wants.
The same is valid for an interruption by opening the door.
w
There is no deleting function integrated in the ON/OFF key S0.
w
If the cycle is interrupted by using the ON/OFF key, all displays go out.
w
The cycle run is continued by switching on using the ON/OFF key S0 resp.
by closing the door, without that another key actuation becomes necessary.
Information: The cycle is continued with a short time delay.
w
All displays and confirmations appear in the same condition as before the interruption.
l
What happens when opening and closing the door?
w
The appliance is switched on and in the "prestart" mode
w
After opening the door all indications keep to be displayed on the panel. The power
supply of the electronic is fully guaranteed as long as the appliance remains
switched on.
w
The door is opened during the running cycle
w
After opening the door all indications keep to be displayed on the panel, as long as
the appliance keeps to be switched on by using the ON/OFF key S0.
w
After closing the door the appliance will start automatically and the cycle run
will be continued.
Attention:
w
When the 1. regeneration has been reached in the program part "drying" it is valid:
w
When the door is open longer than 30 seconds, the program will be deleted.
When the door has been closed, the appliance will be automatically again in the
"prestart" mode. A new program could be selected again immediately.
w
Switching off the appliance by pressing the ON/OFF key S0 also deletes the
current program from that moment.
(see description page B 3 / "Input philosophy program selection")
l
What happens in case of resp. after a power failure?
w
In case of a power failure the appliance behaves as when switched off using the
ON/OFF key.
(see description above / under "Interrupt program")
w
After the mains have returned the appliance behaves as after being switche on using
the ON/OFF key S0.
w
After a power failure the cycle continues without any necessary key actuations.
28