Table of Contents
Advertisement
6.9. Input philosophy - displays
All displays are designed as LED displays and are available depending on the appliance variant.
Start-time preselection and run time are indicated via a display only with the EDW1503.
A special feature with fully integrated appliances is the condition that there are no control and
display elements visible when the door has been closed.
l
Displays for program selection and options
Ä
Above resp. next to a program or option key there is generally a corresponding LED
to confirm the selected function.
Ä
They are lit permanently during the whole cycle run.
l
Display for start-time preselection (SZV)
Ä
The start-time preselection is indicated via a 2.5-digit display.
Ä
The display indicates the start time in hours.
Ä
The start time is counted down to 0h in steps of hours.
Ä
The start-time setting is displayed scrolling.
1h - 2h - 3h - ... - 19h - 0h (SZV off) - 1h - 2h - ...
Ä
When the start-time preselection has run down, the display indicates the run time to be expected
of the selected washing cycle in minutes.
l
Run time display (RLA)
Ä
The remaining run time is indicated via a 2.5-digit display.
Ä
The display indicates the still remaining washing time in minutes.
Ä
The run time is updated depending on the program. The update is executed in changes of
program parts. In doing so the start time can correct downward in jumps, or the display is
stopped until the time is synchronized again.
l
Information displays
Ä
The LED position is depending on the programming of the variant.
They can be programmed toany LED which is not programmed with a program or option key.
Ä
The LEDs are lit permanently from switching on the appliance by ON/OFF key S0,
until the momentof the started program. Furthermore, the LEDs are lit when the cycle end
has been reached until the appliance is switched off.
Ä
The information LEDs go out during the whole cycle run!
w
LED display "salt"
Ä
LED is lit in case of a lack of salt
Ä
LED goes out when salt has been refilled
(Depending on the salt dissolution it can take some time until the LED goes out)
Information: LED display "salt" goes out with hardness setting 1
w
LED display "rinse-aid"
Ä
LED is lit in case of a lack of rinse-aid
Ä
LED goes out after rinse-aid has been refilled
Information: The rinse-aid addition can be deactivated completely by the customer.
If the option "3 in 1" is selected (special tablet option) neither the "salt" LED nor the
"rinse-aid" LED is selected.
w
LED display "water"
Ä
LED is lit when there is no or too less water filling into the appliance.
A reason for that could be, for example, a closed water tap.
Ä
The program is stopped and can be continued when the fault has been eliminated
by actuating the program key.
(see also description page B 19 / "Survey of fault displays - fault 10")
(no regeneration necessary - indication in the display "1L")
This also deactivates the LED display "rinse-aid".
(see description page B 12 / "Deactivation of rinse-aid addition")
29
Advertisement
Table of Contents
