Advertisement
Quick Links
GUARANTEE
Your Elecro heater is guaranteed for one year from the date of purchase against faulty
workmanship and materials.
ELECRO ENGINEERING LTD will replace or repair, at it's discretion, any faulty units or
components returned to the company for inspection. Proof of purchase may be required.
ELECRO ENGINEERING LTD will not be liable in cases of incorrect installation of the
heater, or inappropriate use, or neglect of the heater.
CE Declaration Of Conformity
Elecro declares that the herewith products or ranges
ELECTRIC AQUATIC HEATER RANGE
Are in conformity with the provisions:
of the ELECTROMAGNETIC COMPATIBILITY directive 89/336/EEC, as amended
93/068/EEC. Controlled by AEMC Measures laboratory—technical report no P96045T
The harmonised standards have been applied: EN 55014—EN 55104
of the LOW VOLTAGE directive 73/23/EEC.
The harmonised standards have been applied
EN 60335-2-35
ELECRO ENGINEERING LTD
Tel: +44 (0)1438 749 474
Fax: +44 (0)1438 361 329
Website: www.elecro.co.uk
E-mail: info@elecro.co.uk
© Copyright 2004 Elecro Engineering Limited
EN 55011
EN 55022
CEI 801-4
CEI 801-2
CEI 801-3
Unit 14
Leyden Road
Stevenage
Hertfordshire
SG1 2BW
UK
TiTANIUM
Aquatic Heater
Installation Instructions
& Operating Manual
P
R
C
LEASE
EAD
AREFULLY
Incorrect Installation Will Effect Your Warranty
Do Not Discard, Keep For Future Reference
B
I
EFORE
NSTALLING
Advertisement
Related Manuals for Elecro Engineering Titanium
Summary of Contents for Elecro Engineering Titanium
-
Page 1: Ce Declaration Of Conformity
Your Elecro heater is guaranteed for one year from the date of purchase against faulty workmanship and materials. ELECRO ENGINEERING LTD will replace or repair, at it’s discretion, any faulty units or components returned to the company for inspection. Proof of purchase may be required. - Page 2 Your Elecro heater must be screw fixed to a firm base or wall. The heater MUST be [Blank Page For Your Notes] horizontal and upright i.e. with the control enclosure located above the Titanium flow tube (see diagram below). Under no circumstances should the heater be oper- ated in any other orientation.
-
Page 3: Weather Protection
ROUBLE HOOTING ONTINUED It is essential that the pipe work connecting to and from the heater has a minimum Possible Cause 3.) Insufficient Flow bore (internal diameter) of 1¼’’ (32-mm). The flow rate through the heater needs to be confirmed to be sufficient. Switch off the circulating pump, close the ball valve unions and un-screw the flow switch. -
Page 4: Troubleshooting
LECTRICAL ONNECTION ROUBLE HOOTING Heater will not switch from standby to on (red light) The heater must be installed in accordance with the country / regional requirements & regulations. In any event the work must be carried out by a qualified electrician, In most cases this will be the result of one of the following not being met. -
Page 5: Time Switching
1,000-litres per Elecro TiTANIUM Aquatic heaters are suitable for use with salt water and are also hour of flow (220 UK gallons) and the digital thermostat is set to a value higher unaffected by PH levels. -
Page 6: Hour Timer
Switch Position Function 24 H (If Fitted) IMER In this position the time clock I = Top Position Manual Override = ON: Programming Guide - Tactic Synchronous & Quartz is by-passed, and will not affect the operation of the heater. Setting Up - The Outer dial will need to be set to the current time (when the heater has been installed and has a constant power supply).