Cutting Equipment - Husqvarna 536LiRX Operator's Manual

When loosening and tightening the saw blade nut, there
is a risk of injury from the teeth of the saw blade. You
should therefore always ensure that your hand is shielded
by the blade guard when doing this. Always use a socket
spanner with a shaft that is long enough to allow this. The
arrow in the diagram shows the area where you should
operate the socket spanner when loosening or tightening
the nut.
The nylon lining inside the locking nut must not be so worn
that you can turn it by hand. The lining should offer a
resistance of at least 1.5 Nm. The nut should be replaced
after it has been put on approx. 10 times.

Cutting equipment

Li-ion Li-ion
This section describes how to choose and maintain your
cutting equipment in order to:
• Reduce the risk of blade thrust.
• Obtain maximum cutting performance.
• Extend the life of cutting equipment.
IMPORTANT!
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Refer to the instructions for the cutting attachment to
check the correct way to load the line and the correct
line diameter.
Keep the teeth of the blade correctly sharpened! Follow
our recommendations. Also refer to the instructions on
the blade packaging.
The blade should be completely stationary once the
throttle has returned to its original position.
WARNING! Always remove the battery
!
before you work on any part of the
cutting equipment. It continues to rotate
even after the power trigger has been
released. Check that the cutting
equipment has stopped completely and
remove the battery before you start any
work on it.
Using an incorrect cutting attachment or
an incorrectly sharpened blade
increases the risk of blade thrust.
Always wear protective gloves.
12 – English
GENERAL SAFETY PRECAUTIONS
Grass blades and grass knifes are intended for cutting
coarse grass.
A trimmer head is intended for trimming grass.
General rules
Only use cutting attachments with the guards we
recommend! See the chapter on Technical data.
Keep the cutting edge properly sharpened! Follow our
instructions and use the recommended sharpner. A
damaged or badly sharpened blade increases the risk of
accidents, snags and thrust.
Keep the teeth of the blade correctly sharpened! Follow
our instructions and use the recommended file gauge. An
incorrectly sharpened or damaged blade increases the
risk of accidents.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be replaced.
WARNING! Using an incorrect cutting
!
attachment or an incorrectly sharpened
blade increases the risk of blade thrust.
WARNING! Always discard a blade that is
!
bent, twisted, cracked, broken or
damaged in any other way. Never attempt
to straighten a twisted blade so that it
can be reused. Only use original blades
of the specified type.