Assembly Of Grass Blade And Grass Cutter; Adjusting The Harness And Trimmer; Standard Harness - Husqvarna 536LiRX Operator's Manual

Assembly of grass blade and
grass cutter
Li-ion Li-ion
WARNING! When fitting the cutting
!
attachment it is extremely important that
the raised section on the drive disc/
support flange engages correctly in the
centre hole of the cutting attachment. If
the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
G
F
E
D
B
A
C
NOTE!
Use the recommended blade guard.
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the L key (C) into the hole to lock the shaft.
• Place the blade (D), support cup (E) and support
flange (F) on the output shaft.
ASSEMBLY
• Fit the nut (G). Tighten the nut to a torque of 35-50 Nm
(3.5-5 kpm). Use the socket spanner in the tool kit.
Grasp the handle of the spanner as close to the
trimmer guard as possible.
Adjusting the harness and
trimmer
!

Standard harness

Quick release
At the front is an easily accessible, quick release. Use this
if the engine catches fire or in any other emergency
situation that requires you to free yourself from the
machine and harness.
WARNING! When using a trimmer it must
always be hooked securely to the
harness. Otherwise you will be unable to
control the trimmer safetly and this can
result in injury yourself or others. never
use a harness with a defective quick
release.
–
English 15