Assembly; Motor Cover; Handwheel Assembly; Miter Gauge And Fence Storage Hooks - Jet XACTA Saw Deluxe Operating Instructions And Parts Manual

Assembly

Motor Cover

Referring to Figures 1 and 2:
•
Tools: 17mm Wrench, 12mm Wrench
1. Remove shipping bracket (A) securing the
motor (C) to table.
2. After the shipping bracket has been removed,
install the screw (B) back into the motor
support bracket. The upper screws will be used
to later to hold the extension wing in place.
3. Remove shipping bracket (D) holding switch
assembly (E) to table.
bracket (D); it will be used to install the switch.
4. Remove the remaining hex cap screw, lock
washer, and flat washer (F and Fig. 5) in the
table edge.
5. Install motor cover (G) by aligning the pins (H)
on the cover with brackets on the cabinet.
6. Fasten cover by pulling out the latch (J),
closing the door, and releasing the latch.

Handwheel Assembly

Referring to Figure 3:
Hardware: (2) Handle & Handwheel (C),
(2) Lock Knob (D), (2) Shaft Key (A)
Tools: 3mm hex wrench
The front handwheel (E) is installed at the factory.
Install the side handwheel (C) as follows:
1. Line up the key (A) (taped to shaft) on the
shaft (B) with the key way in the handwheel (C)
and slide the handwheel onto the shaft.
2. Tighten the set screw on the handwheel hub
(3mm hex wrench) securely to hold in place.
3. Install the center lock knob (D) by inserting into
center hole in the shaft and threading in a
clockwise direction.
4. Install the remaining handwheel assembly (E)
in the same manner.

Miter Gauge and Fence Storage Hooks

Referring to Figure 3:
•
Hardware: (1) Small Hook (F) , (2) Large Hook (K),
(6) 1/4" Flat Washers (J), (6) 1/4" Lock Washers
(H), (6) 1/4 x 5/8 Socket Head Cap Screws (G)
•
Tools: 5mm hex wrench
Mount the small hook (F) and two large hooks (K)
to the side of the saw cabinet with six each
socket head cap screws (G),
and 1/4" flat washers (J). Tighten with hex wrench.
Do not discard the
1/4 x 5/8
lock washers (H)
1/4"
9
Figure 1
Figure 2
Figure 3