Install Battery Cell; Remote Sensor - RCA CC618 User Manual

Remote Control
Lithium Cell Installation
The remote's lithium cell is packed separately. Install it as follows:
Cautions: Lithium cell battery. Replace only with 3-volt lithium cell – such as CR2025.
Use of other cell presents a risk of fire or explosion. Must be disposed of properly. Never
handle punctured or leaking cell. May cause burns or personal injury.
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed,
consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate.
1. Turn remote over, insert a pencil or
paper clip in small hole and remove
battery holder.
2. Insert lithium cell in holder with its
positive (+) terminal facing up.
3. Replace battery holder in remote until
it clicks into place.

Remote Sensor

The remote operates the camcorder by infrared light, so it is protected from electrical
and sound interference. However, the remote must be aimed directly at the
camcorder's remote sensor. There cannot be any obstructions between them.
Remote Control Sensor
Note: The camcorder may not respond to the remote if its sensor is exposed to direct
sunlight or strong artificial light.
Back of
Remote Control
Holder
Insert Pencil Here
Lithium Cell
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace cell when camcorder fails to respond
to remote.
Remove cell from remote if it will not be used
for a month or more. This will prevent
possible damage from cell leakage.
If leakage occurs, wipe up liquid inside
compartment and replace cell.
17