Table of Contents
Advertisement
Lithium
Cell Installation
The remote's lithium cell is packed separately. Install it as follows:
Holder
I
Back°f
1
_Remote Control
Insert Pencil Here
Lithium Cell
1. Turn remote over, insert a pencil or
paper clip in small hole and remove
battery holder.
2. Insert lithium cell in holder with its
positive (+) terminal facing up.
3. Replace battery holder in remote until
it clicks into place.
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace cell when camcorder fails to respond
to remote.
Remove cell from remote if it will not be used
for a month or more. This will prevent
possible damage from cell leakage.
If leakage occurs, wipe up liquid inside
compartment and replace cell.
Remote Sensor
The remote operates the camcorder by infrared light, so it is protected from electrical
and sound interference.
However, the remote must be aimed directly at the
camcorder's remote sensor. There cannot be any obstructions between them.
Remote Control Sensor /
_l//
//_
Note: The camcorder may not respond to the remote if its sensor is exposed to direct
sunlight or strong artificial light.
17
Advertisement
Table of Contents
