Armrest Adjustment - Invacare Spectra Plus User Manual

6

Armrest Adjustment

The armrest can be pre-set for height by positioning the self-
tapping screw (F) in one of the holes in the armrest tube. To
adjust the height of each armrest, first release the locking lever
(E) which clamps the arm tube, while holding onto the armrest.
Move the armrest to the desired height position, re-tighten the
locking wing screw (E). The locking lever (if fitted) can be re-
positioned without losing the clamping pressure, pull the lever
slightly outwards and turn to a more suitable locating angle.
The padded side panel can also be set to a desired height. Loosen
the slotted screw (D) located in the fixing bracket, re-tighten when desired position is achieved.
The transverse width adjustment is achieved by releasing locking lever (G) and positioning the
armrest tube to width required and re-tightening locking lever (G). To remove the transverse width
adjustment armrest assembly complete to allow removal of the front battery box/controller as-
sembly: remove seat, release locking lever (G), depress spring button lock (F) and withdraw
complete armrest unit sideways. The battery box assembly can now be
lifted as per instructions.
NOTE:
When re-assembling to chair always ensure the spring button lock (F) is
on the inside of the horizontal mounting tube of the sideframe to prevent
accidental dismantling of armrest unit.
CAUTION:
The armrests are not intended for carrying the wheelchair.
37
1446685 Spectra Plus Seat Riser UG GB 0605.PMD 37 8/17/2005, 10:37 AM