NOTE
Care must be taken when stowing the detached parts
for transportation to ensure that no damage occurs,
particularly to the brake housing and gearbox unit.
To re-attach the motor assemblies, align the bottom
tube rail with the tube of the motor assembly and push
firmly home. Re-tighten fully the knurled locking knob A.
Do the same for both sides. For ease of operation, it is
advisable to re-attach the motor assemblies as the first
operation in the reassembly of the wheelchair after
transportation.
NOTE
The disassembly and reassembly of the motor assemblies can be handled and attached easier if
the chair is carefully tipped onto the front, taking into account that the leg rests are not attached.
The chair can be transported disassembled safely in a suitable vehicle. Reversing the above
procedures will make your chair ready at your destination.
14.2
Drive wheel removal
To remove the rear drive wheels for puncture repairs carefully follow these instructions.
Release the four bolts shown as A in the diagram (opposite page). Check the tyres for wear, if
excessive, replacement is recommended.
62
1446685 Spectra Plus Seat Riser UG GB 0605.PMD
62
8/17/2005, 10:38 AM