Tray Assembly - Invacare Spectra Plus User Manual

16

Tray Assembly

NOTE
Ensure that the joystick control unit is switched OFF before fitting, removing or adjusting the Tray
assembly.
The tray assembly comes ready assembled and is designed to fit to either the left or right hand side
of the wheelchair.
The cut-out section is to accommodate the Joystick Control unit and determines which side the tray
is fitted i.e. Joystick Control fitted to the right hand side, therefore the tray fixings will be fitted to the
left hand side, and vice-versa.
Follow these simple instructions to fit:
1. Remove the two screws A holding the arm pad to armrest support tube B.
2. Fit the slide mounting tube C beneath the armrest support tube using the existing screws, (see
diagram). Tighten the screws securely, (do not over tighten as this will damage the T-nut inserts
within the arm pad).
3. Loosen the wing screw D and slide the tray support tube extension into the slide mounting tube C.
4. With the occupant seated in the chair, adjust the tray to a comfortable working position, tighten
wing screw D.
5. Side to side lateral adjustment can be achieved by loosening the 4 screws E and sliding the tray
surface to the required position.
6. Ensure the tray is firmly positioned, level and central to the occupant's requirements.
66
1446685 Spectra Plus Seat Riser UG GB 0605.PMD 66 8/17/2005, 10:38 AM