• To re-locate the backrest assembly, ensure the pins are correctly aligned into the slots of the
mounting bracket, fully re-tighten the hand-wheel on both sides.
8.3
Armrest Adjustment
8.3.1 Setting the height of the armrests
• The armrest can be pre-set for height by
positioning the self-tapping screw (F) in one of
the holes in the armrest tube.
• To adjust the height of each armrest, first
release the locking lever (E) which clamps the
arm tube, while holding onto the armrest.
• Move the armrest to the desired height
position, re-tighten the locking wing screw (E).
The locking lever (if fitted) can be re-
positioned without losing the clamping
pressure, pull the lever slightly outwards and
turn to a more suitable locating angle.
• The padded side panel can also be set to a
desired height. Loosen the slotted screw (D)
located in the fixing bracket, re-tighten when
desired position is achieved.
42