Armrest Adjustment - Invacare Spectra Plus User Manual

Armrest Adjustment

Armrest Adjustment
The armrest can be pre-set for height by positioning the self-tapping screw (F) in one of
The armrest can be pre-set for height by positioning the self-tapping screw (F) in one of
the holes in the armrest tube. To adjust the height of each armrest, first release the locking
the holes in the armrest tube. To adjust the height of each armrest, first release the locking
lever (E) which clamps the arm tube, while holding onto the armrest. Move the armrest to
lever (E) which clamps the arm tube, while holding onto the armrest. Move the armrest to
the desired height position, re-tighten the locking wing screw (E). The locking lever (if
the desired height position, re-tighten the locking wing screw (E). The locking lever (if
fitted) can be re-positioned without losing the clamping pressure, pull the lever slightly
fitted) can be re-positioned without losing the clamping pressure, pull the lever slightly
outwards and turn to a more suitable locating angle.
outwards and turn to a more suitable locating angle.
The padded side panel can also be set to a desired height. Loosen the slotted screw (D) located in the
The padded side panel can also be set to a desired height. Loosen the slotted screw (D) located in the
fixing bracket, re-tighten when desired position is achieved.
fixing bracket, re-tighten when desired position is achieved.
Width Adjustment
Width Adjustment
The transverse width adjustment is achieved by releasing
The transverse width adjustment is achieved by releasing
locking lever (G) and positioning the armrest tube to width
locking lever (G) and positioning the armrest tube to width
required and re-tightening locking lever (G). To remove the
required and re-tightening locking lever (G). To remove the
transverse width adjustment armrest assembly complete
transverse width adjustment armrest assembly complete
to allow removal of the front battery box/controller
to allow removal of the front battery box/controller
assembly: remove seat, release locking lever (G), depress
assembly: remove seat, release locking lever (G), depress
spring button lock (F) and withdraw complete armrest unit
spring button lock (F) and withdraw complete armrest unit
sideways.
sideways.
NOTE: When re-assembling to chair always ensure the
NOTE: When re-assembling to chair always ensure the
spring button lock (F) is on the inside of the horizontal
spring button lock (F) is on the inside of the horizontal
mounting tube of the sideframe to prevent accidental
mounting tube of the sideframe to prevent accidental
dismantling of armrest unit.
dismantling of armrest unit.
CAUTION: The armrests are not intended for carrying the wheelchair.
!
CAUTION: The armrests are not intended for carrying the wheelchair.
5