Oven Vent(S) - Maytag MEW9530DS User Instructions

2. Using 2 hands, lift up on the front edge of the rack and the
sliding shelf together. Slowly push rack and sliding shelf to the
back wall of the oven so the front edge of the sliding shelf sits
on the rack guides, located on the sides of the oven.
The front edge of the rack and the sliding shelf should be higher
than the back edge.
3. Using 2 hands, lift up on the front edge of the rack and sliding
shelf together.
4. Pull out the rack and sliding shelf.
To Replace Roll-out Rack
1. Using 2 hands, grasp the front of the closed rack and the
sliding shelf. Position the closed rack and the sliding shelf on
the rack guide.
2. Using 2 hands, lift up on the front edge of the rack and the
sliding shelf together.
3. Slowly push the rack and the sliding shelf to the back of the
oven until the back edge of the rack pulls over the end of the
rack guide.
To avoid damage to the sliding shelves, do not place more than 25
lbs (11.4 kg) on the rack.
Do not clean the roll-out extension rack in a dishwasher. It may
remove the rack's lubricant and affect its ability to slide.
See the "General Cleaning" section for more information.

Oven Vent(s)

A
B
C
D
E
F
G
Single and Double Oven
A. Control panel
B. Oven vent
C. Single oven or upper double oven
G. Bottom vent
The oven vent(s) should not be blocked or covered since they allow
the inlet of fresh air into the cooling system. Also, the bottom vent
should not be blocked or covered since it allows the inlet of fresh
air into the cooling system and the outlet of hot air from the cooling
system. Blocking or covering vents will cause poor air circulation,
affecting cooking, cleaning and cooling results.
Baking and Roasting
Preheating
When beginning a Bake cycle, the oven will begin preheating after
Start is pressed. The oven will take approximately 13 to 19 minutes
to reach 350°F (177°C) with all of the oven racks provided with your
oven inside the oven cavity. Higher temperatures will take longer to
preheat. The preheat cycle rapidly increases the oven temperature.
The actual oven temperature will go above your set temperature to
offset the heat lost when your oven door is opened to insert food.
This ensures that when you place your food in the oven, the oven
will begin at the proper temperature. Insert your food when the
preheat tone sounds. Do not open the door during preheat before
the tone sounds.
8
Rapid Preheat
Rapid Preheat can be used to shorten the preheating time. Only
one standard flat oven rack should be in the oven during Rapid
Preheat. Extra racks should be removed prior to starting Rapid
Preheat. The preheating cycle should be completed before placing
food in the oven. When the Rapid Preheat cycle is complete, the
oven starts a normal Bake cycle.
IMPORTANT: Rapid Preheat should be used only for one-rack
baking.
Oven Temperature
While in use, the oven elements will cycle on and off as needed to
maintain a consistent temperature, but they may run slightly hot or
cool at any point in time due to this cycling. Opening the oven door
while in use will release the hot air and cool the oven, which could
impact the cooking time and performance. It is recommended to
use the oven light to monitor cooking progress.
NOTE: On models with convection, the convection fan may run in
the non-convection bake mode to improve oven performance.
When broiling, preheat the oven for 2 minutes before putting food
in unless recommended otherwise in the recipe. Position food on
grid in a broiler pan, and then place it in the center of the oven rack.
Close the oven door to ensure proper broiling temperature.
NOTE: Odors and smoke are normal the first few times the oven is
used or if the oven is heavily soiled.
Changing the temperature when broiling allows more precise
control when cooking. The lower the broil setting, the slower the
cooking. Thicker cuts and unevenly shaped pieces of meat, fish
and poultry may cook better at lower broil settings. Place the food
in the upper or lower oven. Refer to the "Positioning Racks and
Bakeware" section for more information.
On lower settings, the broil element will cycle On and Off to
maintain the proper temperature.
■
During convection cooking, the fan provides hot air circulation
throughout the oven. The movement of heated air around the food
can help to speed up cooking by penetrating the cooler outer
surfaces. Food cooks more evenly, browning and crisping outer
Double Oven
surfaces while sealing moisture inside.
D. Upper oven
During the Convect function, the ring element, bake and broil
E. Oven vent
elements, and the fan operate to heat the oven cavity. If the oven
F. Lower oven
door is opened during convection cooking or preheating, the fan
G. Bottom vent
turns off immediately and the element(s) will turn off after
30 seconds. Once the door is closed, the element(s) will turn back
on.
NOTE: It is normal for the convection fan to run during non-
convection cycles as well as during preheat.
■
■
■
■
■
Broiling
For best results, use a broiler pan and grid. It is designed to
drain juices and help avoid spatter and smoke.
If you would like to purchase a broiler pan, one may be ordered.
Please refer to the "Accessories" section for more information.
Convection Cooking - Single or Upper Oven Only
(on some models)
It is important not to cover foods so that surface areas remain
exposed to the circulating air, allowing browning and crisping.
Keep heat loss to a minimum by only opening the oven door
when necessary. It is recommended to use the oven light to
monitor cooking progress.
Choose cookie sheets without sides and roasting pans with
lower sides to allow air to move freely around the food.
Test baked goods for doneness a few minutes before the
minimum cooking time with a method such as a toothpick.
Use a meat thermometer to determine the doneness of meats
and poultry. Check the temperature of pork and poultry in 2 or 3
different places, including the thickest part.