Fantasea Line FG7X Instruction Manual page 7

Numbered descriptions below refer to corresponding numbers on the top/front housing graphic on the
previous page:
1. Zoom Lever – This control activates the camera zoom button.
a. In Shooting Mode –
i. Pull the zoom lever clockwise to zoom in, so that the subject fills a larger area of the
ii. Push the zoom lever counterclockwise to zoom out, increasing the area visible in the
b. In Playback Mode - use the zoom lever as playback lever (index or magnify).
2. Shutter Release – Activates the camera shutter release button. Depressing the shutter release
button halfway allows the camera to focus prior to taking the picture.
3. Mode Dial – Rotate this dial while applying slight downward pressure to change shooting modes.
Important Notice! It is recommended to align housing and camera mode dials prior to installing the
camera inside the housing. Please refer to the section "Installing the Camera" for more information.
At the same time, note that shooting mode markings on the housing mode dial might not indicate
the value set by the corresponding camera dial, even if aligned prior to camera installation inside the
housing. Therefore, it is important to check the shooting mode selected and displayed on the camera
LCD screen. Even in such cases, since mode labels on the housing mode dial appear according to their
order on the camera mode dial, they can still assist with the amount of rotating required in order to
reach the desirable shooting mode.
4. Exposure Compensation Dial - Rotating this dial operates the camera exposure compensation dial
to the opposite direction. Note that housing exposure compensation dial directions are opposite to
camera exposure compensation dial directions when rotated.
a. In order to set a higher exposure compensation value, rotate the exposure compensation
dial counterclockwise.
b. In order to a lower exposure compensation value, rotate the exposure compensation dial
clockwise.
Note that value markings on the housing exposure compensation dial do not indicate the value set by
the corresponding camera dial, even if aligned prior to camera installation inside the housing.
Therefore, it is important to check the exposure compensation value selected and displayed on the
camera LCD screen.
5. On/Off- Pushing this control activates the camera power switch button and turns the camera on/off.
frame and for close-up and macro images to be taken.
frame.
FG7X Housing Instruction Manual 20150101
7