Installation Checklist - Nice Apollo 4300 SW User Manual

29 - INSTALLATION CHECKLIST

Left box is for installer check off and the right box is for cus-
tomer check off.
1. The gate has been checked to make sure it is level and moves freely
in both directions.
2. Potential pinch areas have been guarded so as to be inaccessible
OR have contact and/or non-contact obstruction sensing devices
installed.
3. The installer has installed one or more contact or non-contact
obstruction sensing devices, in compliance with UL325 require-
ments for this installation.
4.
installed, a minimum of seven feet from the gate. The customer has
gate.
5. Warning signs have been installed on each side of the gate in highly
visible locations. The customer has been informed that these signs
must remain at all times.
6. There are no controls installed on the gate operator, or within 8 feet
of the gate.
7. The installer has properly adjusted the obstruction sensing fea-
ture and has tested the gate to make sure that the gate stops and
reverses a short distance with minimal resistance applied (Approxi-
mately 40 lbs. on a swing gate, at the end of the gate.
8. The installer has instructed the customer in the proper use of the
gate operator and reviewed all of the operational functions, obstruc-
tion sensing devices, warning beeper and reset, etc.
9. The installer has instructed the customer in the proper use of the
operator's manual disconnect feature. The manual disconnect must
never be used while the gate is in motion. The power switch must be
turned off before using the manual disconnect and disengaging the
operator.
10. The installer has reviewed all safety instructions with the customer,
and has left the safety instructions and owner's information sheets
for their reference.
11. The installer has answered any questions the customer has regard-
ing the operation of the gate operator and gate operator safety pre-
cautions.
12. The The installer has explained to the customer that a regular main-
tenance schedule for both the gate and the gate operator is recom-
mended.
Installation Acceptance
Address where opener is located
Installer name, number and address
End user name and telephone number
27