Using Wireless 2 (External Antenna) - Icom AP-90M Instruction Manual

3
CONNECTING TO A WIRELESS LAN (BASIC)
6. Setting the Wireless Bridging function (Continued)
Wireless Settings > Wireless 2 > Wireless Bridging (WBR)
 Using Wireless 2 (External antenna)
Setting two AP-90Ms (illustration: master (ath4) and client) with the following settings are used as an ex-
ample.
• Refer to "Wireless Bridging function" for conditions to use the function. (+p.1-9)
• The client unit channel automatically changes to the master unit channel.
The channel "036 CH (5180 MHz)" (Wireless 2) is set as default and it is used as the example for this description.
• The client virtual AP (ath7) cannot be used when the wireless bridging function is set.
• The IP address which was set in "Changing the IP address" (+p.2-8) is used as an example.
Master (+p.3-19)
[Wireless LAN]
[Virtual AP]
[Security]
[Wireless Bridging] Wireless Bridging:
Client (+p.3-21)
[Wireless Bridging] Wireless Bridging:
[Client Settings]
• The client's "Interface" cannot be changed from "wbr17."
Master settings
Channel:
Virtual AP:
SSID:
Authentication:
Encryption:
PSK:
BSSID:
Cable LAN
Channel:
Interface:
Virtual AP:
SSID:
Authentication:
Encryption:
PSK (Pre-Shared Key): wirelessmaster
Operating Mode:
Interface:
Client BSSID:
Operating Mode:
SSID:
Authentication:
Encryption:
PSK (Pre-Shared Key): wirelessmaster
036 CH (5180 MHz)
ath4
WIRELESSLAN-0
WPA2-PSK
AES
wirelessmaster
00-90-C7-00-00-02 (Client BSSID)
Master
192.168.0.1
036 CH (5180 MHz) (default)
ath4
Enable (default)
WIRELESSLAN-0 (default)
WPA2-PSK
AES
Enable
Master
wbr8
00-90-C7-00-00-02 (Client BSSID)
• Check the Client BSSID by enabling the Wireless Bridging on the
client's "Wireless Bridging (WBR)" screen.
Enable
Client
WIRELESSLAN-0 (default)
WPA2-PSK
AES
Client settings
SSID:
Authentication:
Encryption:
PSK:
Wireless Bridging
connection
Client
192.168.0.2
3-14
WIRELESSLAN-0
WPA2-PSK
AES
wirelessmaster
Cable LAN
The settings above are just examples.
(+Continued on the next page)