Table of Contents
Advertisement
Optical Adjustments
R-FOCUS ADJUSTMENT
1. Insert paper etc. in Red and Blue panel to block the
red and blue light so that only green light is projected.
2. Press the ZOOM (+) button to "Wide" position (to
increase image size) and press the FOCUS (+) or (-)
button to make a picture in sharp focus.
3. Insert paper etc. in Blue and Green panel to block the
blue and green light so that only red light is projected.
4. Loosen the 4 screws "B" with the 2.0mm hex driver,
see Fig.1b.
5. Insert the slot type screwdriver in the slots
and
(Fig.1b) and gently turn the screwdriver until
the each corner of screen is in sharp focus. The rela-
tion of adjustment points and screen corners are indi-
cated with
,
,
and
6. Tighten the 4 screws "B" and securely attache the
Red panel unit.
B
Red
LCD
Panel
B
Fig.1b
,
shown in Fig.1b and Fig.2.
B
B
Green
LCD Panel
Fig.2
B-FOCUS ADJUSTMENT
1. Insert paper etc. in Red and Blue panel to block the
red and blue light so that only green light is projected.
2. Press the ZOOM (+) button to "Wide" position (to
increase image size) and press the FOCUS (+) or (-)
button to make a picture in sharp focus.
3. Insert paper etc. in Red and Green panel to block the
red and green light so that only blue light is projected.
4. Loosen the 4 screws "C" with the 2.0mm hex driver,
see Fig.1c.
,
5. Insert the slot type screwdriver in the slots
and
(Fig.1c) and gently turn the screwdriver until
the each corner of screen is in sharp focus. The rela-
tion of adjustment points and screen corners are indi-
cated with
,
6. Tighten the 4 screws "C" and securely attache the Blue
panel unit.
Fig.1c
-36-
,
and
shown in Fig.1c and Fig.2.
C
C
Green
LCD Panel
The numbers indicate the focus
effective part when moving the
numbered adjusting slots on
Fig.1.
,
,
C
Blue
LCD
Panel
C
Advertisement
Table of Contents
