Controls - NEC MD302C6 Installation & Maintenance Manual

Controls

Power On/Off
Press and hold the switch to turn on/off the display.
NOTE: Wait at least 10 seconds between on/off actions.
MINUS button
Without displaying the OSD on the screen, press this button to switch the input source of
DVI 1. (This function is available only when "ENABLE FUNCTIONS" setting of the direct OSD menu setting is set to
"Enable Switching Input Source" or "Enable Both Functions" (see page 26)).
With the OSD screen displayed, press this button to move the cursor to right/left or up/down.
PLUS button
Without displaying the OSD on the screen, press this button to switch the input source of
DVI 2. (This function is available only when "ENABLE FUNCTIONS" setting of the direct OSD menu setting is set to
"Enable Switching Input Source" or "Enable Both Functions" (see page 26)).
With the OSD screen displayed, press this button to move the cursor to right/left or up/down.
MENU button
Without displaying the OSD on the screen, press this button to switch the input port displayed on the screen. The input port
is switched in the following order: INPUT 1, INPUT 2, and Input 1 + Input 2.
(This function is available only when "ENABLE FUNCTIONS" setting of the direct OSD menu setting is set to "Enable
Switching Input Source" or "Enable Both Functions" (see page 26)).
Press and hold this button to show OSD setting menus.
With the OSD screen displayed, press this button to select and set OSD items.
LCD Luminance Sensor
Caution: Do not touch the LCD luminance sensor. It may cause the set luminance level to change and/or the LCD to fail.
LED Status Indicator
No. LED
1 Off
2 Off
3 Green
4 Blinking green
5 Orange
6 Blinking orange
7 Red/blinking red
Ambient Light Sensor
Power Mode
Off Power off
On Normal (Luminance stabilized)
On Luminance stabilizer on
On Calibrating
On Power management on
On Advanced power management on
On Error (Contact NEC technical support)
English-11
INPUT 1 to DisplayPort 1 or
INPUT 2 to DisplayPort 1 or