Mount Gun - Graco PerformAA 26B570 Instructions Manual

Installation

Mount Gun

Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod [0.5 in. (13
mm) diameter maximum]:
1. Insert the mounting bar (A) through the hole in the
manifold as shown in F
NOTE: Use the 1/8 in. alignment pin (P) to assist in
orienting the gun.
2. Secure the gun to the bar by tightening the
mounting screw (B).
P
A
F . 3: Reciprocating Arm Mount
IG
Stationary Support
To mount the gun on a stationary support (refer to F
4. and to Mounting Hole Layout, page 40):
1. Align the manifold with the alignment pins. Locate
alignment pins and holes per the Mounting Hole
Layout illustration, page 40.
2. Secure the gun to the support with two M5 x 0.8
capscrews (S). The screws must be long enough to
8
. 3.
IG
B
TI8120a
engage the threaded holes in the gun manifold to a
depth of 1/4 in. (6 mm).
F . 4: Stationary Support Mount
IG
Retrofit Adapter Plate
The retrofit adapter plate enables the manifold to be
attached to a variety of bolt patterns.
To mount the gun using the retrofit adapter plate (kit
288197):
1. Mount adapter plate to manifold using the three
screws provided with the kit (F
2. Bolt plate to mounting surface using four M5 x 0.8
capscrews. Refer to the Mounting Hole Layout,
page 40.
.
IG
F . 5: Retrofit Adapter Plate
IG
TI8121a
S
. 5).
IG
TI8180a
3A8553A