Table of Contents
Advertisement
Step 5: Positioning the Pinchwheels
1.
Ensure that the paper is loaded as described, that the right paper
edge does not encroach on the Service Station area and the left
edge does not touch the fan on the back of the machine.
2.
Raise the pinchwheels (if they are not up) by pushing the lever
away from the machine.
3.
Move the pinchwheels to the proper position. See Figure below.
Do not place a pinchwheel over any smooth portion of the drive
shaft. Use the white markers on the carriage rail to find drive
shaft segments when they are covered by paper.
Drive Shaft
Segment
Drive Shaft
Bearing
Step 6 : Insert Front Dancer Bar
1.
Lower the pinchwheels (if they are not down) by pulling the
lever toward the machine.
2.
Insert the front dancer bar into the front dancer bar channel.
Front Dancer
Bar (Silver
light rod)
Pinchwheel
White Driveshaft Markers
27
Advertisement
Table of Contents
