Ioline FlexJet E Quick Start Manual page 18

18 Ioline FlexJet E Quick Start Guide
Caution
Make sure power to the
machine is off before con-
necting the cables.
2. Check that the holes in the endplate line up with the threaded
holes in the leg. If they do not align, check to make sure that the
rear alignment pin is resting in the rear notch on both legs.
3. Insert four / -in button-head screws through the two holes in
5
8
both end plates to connect the head to the stand. Tighten all
four screws with the included T-handle wrench.
Print head attachment
Step 7: Connect the Paper Sensor Cable
1. Make sure power is off to the machine. Find the small plug
clipped to the bottom inside edge of the right endplate.
/ -in
screws—shown here at actual size.
5
8
/ -in Screw
5
8
(2 per side)