Ioline FlexJet E Quick Start Manual page 21

Step 9 : Connect the Communication and Power Cables
1. Turn power off to the printer. Off is marked with a, "0,".
2. Connect the supplied serial cable and power cord to the panel on
the back of the right side of the printer. Lock the serial cable to
the port on the printer with the thumb screws.
3. Plug the printer power
cable into a wall socket or
surge protector.
4. Make sure that power is
off to the computer.
5. Connect the serial cable to
a 9 pin-male-serial port on
the back of the computer.
Tighten the thumbscrews.
Step 10: Install the Software
1. Insert the installation CD-ROM into the computer CD-ROM
drive. The install program should start automatically. If it does
not, select Run from the Start Menu. Browse to the CD-ROM
and double click on iosetup.exe. Press OK to start the install.
2. Install the Ioline FlexPlot and Control Center software. USB
drivers are installed automatically.
The serial port and power socket.
i
Note
Note: The FlexJet E User Guide
contains detailed instructions for
communication setup.
i
Note
On the FlexJet E printer, off is
marked with a, "0," and on with
a,"1.".
Hint
The Installation Disk also
includes electronic copies of
the FlexJet E User Guide and
FlexJet E Quick Start Guide. It
is recommended that you install
these along with Adobe Acrobat
(also included on the disk) to
make help easily accessible.
21